NoiseWorks Audio has recently released a free plugin that automatically finds and removes plosives from voice recordings.
Plosives are a common issue with both vocal and dialogue recordings, often the result of poor mic technique or the absence of a pop-shield. A high-pass filter can tame it, but only by thinning the whole voice, and fixing it by hand means working through a take one pop at a time. PloseAssist finds every pop and turns down only the low end of that short moment. Everything else stays exactly as it was recorded.
Insert it on a voice track and press play. No threshold to set, and most recordings need no adjustment at all.
PloseAssist features
- Automatic detection: PloseAssist recognizes the usual shape of a plosive and ignores normal low-frequency sounds in the voice.
- Targeted processing: It only cuts frequencies below about 250 Hz, and only when a pop occurs. If there is no pop, the signal stays untouched.
- Two controls: Amount adjusts how much each pop is reduced. Sub adds extra reduction below 100 Hz, where the thump is most noticeable.
- Two modes: Use Low Latency for recording and monitoring, and Balance for editing and mixing.
- Visual feedback: Each cut shows up as a red dip on the display, next to a gain reduction meter.
- Delta: This feature plays only what PloseAssist removes, so engineers can make sure no voice is lost.
The plugin is available for Windows and macOS in VST3, AU and AAX formats.
More information: NoiseWorks Audio


