Mozzaik Audio has recently released an update to its word length reduction plugin for Windows and macOS (VST3, AU and AAX).
Dither 4 reduces the signal to any word length from 16 to 24 bits, in steps of one bit. It adds triangular (TPDF) dither of +-1 LSB peak, so the quantization error carries no distortion and no noise modulation, and shapes the remaining noise with a second order filter, 40 dB per decade. At 44.1 kHz the noise is about 37 dB lower at 1 kHz and 13 dB lower at 4 kHz than with flat dither, and it rises above the flat level only above roughly 8.5 kHz. The shaping curve is the same at every sample rate, so at higher rates it moves further up, out of the audio band.
New in version 4, the Amount control is gone: the plugin sets the amount of dither at the level that is correct for TPDF, so there is nothing to set wrong. The interface has three controls: an Off/On toggle with true bypass, a Bits knob and a Bits field. Dither 4 has zero latency and a clip indicator for the output.
Also available is version 1.0 of Mozzaik Monitor, a plugin that adds noise of a very low level to the signal that goes to the DA converter.
Delta-sigma DA converters can produce idle tones and limit cycles when the signal is very quiet or constant: at the end of a reverb tail, in a fade or in a pause. A small amount of noise at the input of the modulator breaks these patterns up. Mozzaik Monitor adds this noise on the monitoring path and leaves the signal itself unchanged. How much it helps depends on the converter.
- Amount from -100 dB to -40 dB, -80 dB by default.
- Shaping between 0 and 20 kHz: Flat, Medium (rises 6 dB per octave) or High (rises 12 dB per octave), so most of the noise is at the top of the band, where hearing is less sensitive.
- Gaussian noise, not correlated between the channels.
- Sample rates from 44.1 to 384 kHz, with the same level of noise between 0 and 20 kHz at every rate. From 88.2 kHz up the noise falls above 20 kHz by 12 dB per octave.
- Off/On with a 10 ms fade, without a click. In the Off position the signal passes unchanged.
Monitor goes at the end of the monitoring path. The recommended starting point is three instances in a chain: High at -80 dB for the upper part of the spectrum, Medium at -85 dB for the mid range and Flat at -100 dB for the low range, each then tuned by ear with the converter in use. The noise of the instances is not correlated, so their levels add as power. For export Monitor is turned Off, or left On in front of Mozzaik Dither if the noise should reach the listener’s converter too.
Mozzaik Dither 4 is available for €EUR 27 + VAT per year, with Mozzaik Monitor included in the same subscription and the same Mozzaik account. Both plugins can be tried without an account; they run for 10 minutes at a time and then switch themselves off.
More information: Mozzaik Audio


